A shaker that sits upright in a cup holder
A low-profile adapter in two parts: the pedestal nests in the car cup holder and the offset cradle on top is fitted to the shaker itself. The cradle is pushed 20 mm off the pedestal axis so a tall shaker clears the console instead of leaning against it.
The default cup measures 87 mm at the floor and 91 mm at the rim, the cradle is 50 mm deep and seats at 85 mm, and the pedestal runs from 70.6 mm at the base to 78 mm at the top. Cradle wall and floor are both 4 mm, the shoulder rises 7 mm and the whole adapter stays low enough to sit under the console lip.
Silicone pads go into the side and floor pockets: Ø10.5 × 3.15 mm with 0.2 mm of pocket clearance, recessed 1.575 mm, at 20 mm and 48 mm up the sides and in a 22 mm floor radius. The cup and car-holder clearances have not been verified against a physical car, so measure your own holder and cup before relying on the fit.