Two devices. One stand.

Two curved cradles with short, filleted front lips and open corners. A recessed groove separates them above a connecting floor, and each back support has its own length.

Phone preview

Both orientations fit the same stand; this changes the preview only.

Sized for a Lenovo Tab M10 Plus (3rd Gen), 158.8 × 251.2 × 7.5 mm, and a OnePlus Nord 4, 162.6 × 75 × 8 mm. Add any case to these measurements.

Device fit

Angle, supports & depth

Millimetres · one piece · six grip pockets

Fit & hardware

Six underside pockets accept adhesive silicone dots, Ø10.5 × 3.15 mm. The pockets are Ø10.75 mm with 1.575 mm recess depth, leaving the dots half exposed. Devices and silicone feet are excluded from the STL.

The tablet stays in portrait orientation. Enter the phone’s long side, short side and thickness with its case fitted; both phone orientations use the same continuous cradle. Both bays share a slot sized to the thicker device plus 1.2 mm, keeping the lips and contact planes aligned. There are no charging cutouts. You set the stand depth: the size line warns when a device’s centre sits behind the rear feet, but check loaded stability and tapping with the actual devices before regular use.

Two cradles, one footprint

Two closed curved cradles hold a portrait tablet beside a phone in either orientation. Both share aligned seats and short front lips that are filleted into the seat, separated by an 8 mm groove above a 2.6 mm connecting floor, with shallow rear heels and six silicone feet underneath. There are no charging cutouts and no separate base plate, so nothing has to be assembled.

The defaults are the bare devices: a OnePlus Nord 4 at 162.6 × 75 × 8 mm and a Lenovo Tab M10 Plus 3rd Gen at 251.2 × 158.8 × 7.5 mm. Add any case to the measurements. Both cradles are cut to the thicker device plus 1.2 mm of clearance, so the thinner one ends up with spare slot space, and combinations wider than 250 mm are refused so the stand still fits the bed.

The stand depth is deliberately not derived from the devices: it has to leave room for the rear curve behind the longer back support, and the page warns when a device's centre ends up behind the rear feet. Six Ø10.5 × 3.15 mm silicone dots fit the underside pockets with 1.575 mm left exposed. Stability depends on the actual devices, cases and desk, so check the resistance to tapping before relying on it.